|
|
[Home] [Search] [FAQ] |
|---|---|
| [Private Message] [Register] [Profile] [Member list] [Log-in] |
| Who's Online: |
| There are 0 member(s), and 1 guest(s) online. |
| [Printable Version] [Post Reply] |
| Author | Message | ||
|---|---|---|---|
|
Anon Deleted Posts : Location : Status : Offline |
camshaft Hi to every one, First time on here and first time owner of a cf bedford, its a 1982 350 with a 2.3 slant engine, has a Pioneer body, and have only had it 4 month.and nothing but problems with the old girl, to many things to list here and bore you all, so I will cut to the problem I have now... I am in need of a camshaft housing or a complete camshaft and housing, one of the tappet adjuster screws has damaged the tappet bucket guide, got some one to fit a new head gasket and it came back running on 3 pots, I then took it down my self to find a valve stuck down, and the bucket jammed in its guide, its taken a chunk out so goosed,,I am not a mechanic, and now I am thinking the mechanic who did the job is not either , buts its done so I am seeking help for this problem,,, Thanks to all for any help
|
 Fri 08 Aug 2014 @ 21:01
|    |
|
Colin Birch Admin Posts : 4277 Location : Pontypridd, South Wales Status : Offline 
|
Have you tried Adrain Bailey? His contact details can be found in the 'where to get cf spares' section at http://cf-uk.co.uk/spares.htm He's expensive but he's either got or can get most CF parts. ---------------------- |
Sat 09 Aug 2014 @ 11:01
|
|
|
bluebedouin Global Moderator Posts : 2444 Location : Northampton,England. Status : Offline 
|
I have a feeling there's one in my garage.I'll have a look later & get back to you. ---------------------- |
Sat 09 Aug 2014 @ 14:04
|
|
|
bluebedouin Global Moderator Posts : 2444 Location : Northampton,England. Status : Offline
|
Not sure if it's the correct one. 
---------------------- |
Sat 09 Aug 2014 @ 19:54
|
|
|
Anon Deleted Posts : Location : Status : Offline |
Hi bluebedouin, First thank you for your fast reply and photos,I am sat here with mine sat on my lap,It does not seem the same, ie it has 5 small ball bearings same as your but mine has 2 larger ball bearing each side of the center channel, other wise it seems the same..I am thinking if I can clean it up ie, get the tappet bucket to run free up and down it sound work, as the bucket has 2 holes in it for the adjuster and a cut away on the casting were you adjust it, so will a little chip out be a problem ????? many thanks again, 
|
Sat 09 Aug 2014 @ 20:46
| |
| Time in GMT | |||
| [Post Reply] | |
 New posts since your last visit |
Administrative Functions: Open/Close/Delete Thread / Move Thread |
 Old post |
Back to the CF-UK Homepage ][ Email CF-UK
Powered by FunkBoard vCF0.74c